DRC+ is a new methodology that algorithmically characterizes design variation through pattern classification. A traditional design rule is used to identify all design structures that share a common configuration. Then, the 2D geometric situations (pattern variations) around the configuration are extracted and classified. Since all such classes share a common configuration, each situation class represents [...]
Fab owners are looking to bring down their energy consumption to match the greening of semiconductors themselves.
Nanotechnology's economic potential will only be harnessed through more basic research, according to a new report from the NSF. Paul Dempsey reports.
As part of our nanotechnology focus, we look at the prospects for graphene and carbon nanotubes in electronics. Paul Dempsey reports.
Morris Chang was in on the ground floor of IC innovation at TI and remains there today as chairman of TSMC. Paul Dempsey reports.
Sematech, the leading research consortium for semiconductor manufacturing, has launched a campaign to recruit members from the fabless sector. The move reflects the importance of making manufacturing decisions earlier in the design flow, and is also intended to get input from designers on implementations of such technologies as 3D interconnects, next-generation lithography and novel materials/structures.
Microelectromechanical systems (MEMS) manufacturing continues to be dogged by a technologically and economically inefficient landscape where too many products demand their own bespoke processes and packages. However, the last three years have seen third-party foundries gain more influence over the sector, bringing greater demands for reuse and DFM considerations, earlier in the design flow. The [...]
The demands of manufacturing closure at advanced process nodes make the traditional design-then-fix flow unmanageable. At 28nm and below, designers need a solution that can address manufacturing issues at any point in the design process, enabling a true correct-by-construction methodology. An effective solution must provide design-rule-check and design-for-manufacturing analysis using the actual foundry-approved signoff rules [...]
Product engineering services can be efficiently outsourced and even the biggest players are doing it, says Michel Villemain
This year's Design Automation and Test in Europe conference heard from a broad range of users and suppliers about the challenges to and solutions for getting optimal yields at advanced process nodes, particularly as the industry advances toward 22nm. This article recaps presentations by four executives at the Dresden-hosted event: Pierre Garnier of Texas Instruments, [...]
View All Sponsors