System Codesign

April 8, 2014
Randall Myers is an Xpedition Flow technical marketing engineer at Mentor Graphics

Straighten up and fly right

Fighter pilots have long trusted highly sophisticated automation. That’s how you can meet the challenges posed by advanced PCB design techniques.
Expert Insight  |  Tags: , , , ,   |  Organizations:
March 27, 2014
Julian Coates is the director of business development for Mentor Graphics Valor division.

Make best-practice lean NPI for PCB a reality

Shifting DFM validation earlier in the flow speeds NPI, cuts respins and gives you a critical edge.
Expert Insight  |  Tags: , , , ,   |  Organizations:
October 27, 2013
Richard Goering, senior manager of technical communications, Cadence

IPC-2581 transfer standard gains momentum

Forty six companies have joined the consortium developing the increasingly important IPC-2581 data transfer standard for PCB designs.
Expert Insight  |  Tags: ,   |  Organizations:
April 10, 2013
Richard Goering, senior manager of technical communications, Cadence

Focus on product creation for effective design

An increasingly important concept in design is that of product creation. An approach based on product creation looks beyond chip or board design.
Expert Insight  |  Tags: , ,   |  Organizations:
October 23, 2012
A same net sliver

Better PCB design using the fabricator’s view

Early use of design for manufacturing can capture PCB yield issues related to pads, copper distribution, same net slivers and more
January 16, 2012

Mechanical CAD integration

MCAD integration provides the means for designers to test the mechanical compatibility of a PCB design – for cooling performance as well as whether the layout will fit into an enclosure without problems.
Guide  |  Tags: , , ,
May 25, 2011

Why Printed Circuit Board Design Matters to the Executive: How PCBs Are a Strategic Asset for Cost Reduction and Faster Time-to-Market

In today’s competitive market place, companies must find new ways to differentiate their products. In response, many companies are turning to electronics to enable new innovative features. As a result, electronics have become even more critical to the product development process. In fact, electronics have become so important, research shows that a focus on the […]

Whitepaper  |  Tags:
November 1, 2008

Bridging the ECAD-MCAD gap

New tools and standards encourage communication between the electrical and mechanical domains, says Pawel Chadzynski. Most major electronics companies have separate electrical (ECAD) and mechanical (MCAD) design organizations. Efficient collaboration between these teams throughout the PCB design process can significantly reduce cycle times, lower the risk of re-spins, and improve quality. The first challenge to […]

Article  |  Tags: , , , ,   |  Organizations: ,
November 1, 2008

Inside the hot zone

Floorplanning informed by thermal analysis can significantly improve PCB layouts, writes Robin Bornoff The number of PCB design constraints seems ever increasing. The risk that a design will fail either functional performance or reliability goals grows for each generation. One increasingly popular trade-off addresses a balance between thermal compliance and signal integrity. Components with high […]

Article  |  Tags:   |  Organizations:
September 1, 2008

Product development efficiency through ECAD-MCAD collaboration

In May 2008, the ProSTEP iViP Association released an agreed data schema and communication protocol to enhance collaboration between electrical and mechanical CAD tools (ProSTEP iViP Recommendation ECAD/MCAD, PSI 5). The article sets out the need for the new standards and how they deliver greater design effi ciencies than existing technologies, such as the IDF […]

Article  |  Tags: , , ,

PLATINUM SPONSORS

Mentor Graphics GLOBALFOUNDRIES Synopsys Samsung Semiconductor Cadence Design Systems
View All Sponsors